8510系列拉压力传感器

• Features

  • 量程范围小，从 0 ... 20 N 到 0 ... 2 MN
  • 可测拉力和压力
  • 过载保护最高可达到量程的5倍
  • 小巧的外形设计
  • 安装方便

• Product data

  型号	8510
  量程范围	0 … 1 N 0 … 2 N 0 … 5 N 0 … 10 N 0 … 20 N
  受力方向	压力和压力
  标准化信号	可选配
  信号输出	1 mV/V
  保护等级	IP20
  过载保护	Yes
  拉盘	No
  受力压头	No
  使用温度范围	-20 ... +80 °C
  具体特点	量程范围小，从 0 ... 20 N 到 0 ... 2 MN 可测拉力和压力 过载保护最高可达到量程的5倍 小巧的外形设计 安装方便

• Description

  The model 8510 bending beam load cell is suitable for measuring small and extremely small applied forces. The mechanical overload protection available for all measuring ranges prevents the sensor from being damaged by excessively high static and quasi-static loads which can occur during measurement and installation.
  
  The sensor can be extended axially, e.g. by a finger, which does not influence the measuring.
  
  Essential application of this sensor include measurement and testing of the following components:
  
      Switches (limit-, micro- and toggle-switches)
      Buttons
      Contact coupling and contact decoupling forces
      Frictional forces
      Spring characteristics
      Tension of wire and string windings
  
  The sensor element consists of a double bending beam with applied strain gauges.
  
  Changes in the ohmic resistance of the strain gauge fullbridge caused by applied forces are converted into electrical voltages. The precise value (characteristic value) of the output voltage, resulting from the application of a rated force to the sensor, is specified in the accompanying calibration protocol.
  
  The sensor has to be mounted by two screws on the cable side. The opposite side is meant to receive applied forces (loads).
  
  Once the rated stress or strain is exceeded by 20 %, further deflection of the bending beam is prevented by an integrated, mechanical stop. This protects the sensor element against permanent deformation.

• Downloads

  Data sheet

  8510参数资料

  EN

  Operation manual

  8510使用手册

  EN

Related products

8431,8432系列