5510报警器

DIGIFORCE®过程控制器的选配附件。

 

OK和/或NOK结果的红绿灯和嗡鸣通知,处理器控制的设备,多种操作模式可选,内部指示灯,外部锁定,前面板的IP65防护等级,适用于台式和面板仪表

  • Features

    • OK / NOK 嗡鸣声音可调节
    • 处理器控制的设备,多达8种不同的操作模式可选
    • 仪器面板正面的OK / NOK灯
    • 外部联锁,操作和显示
    • 坚固的工业环境外壳,前面板IP65
    • 可在台式机上使用或安装到面板仪表
  • Description

    On production floor, the need for optical as well as acoustical notification of OK and NOK parts can be found oftentimes next to the evaluation done by measuring and evaluating instrumentation. Especially for manual work places with a certain allowed time/work piece ratio the additional notification related to the product is wanted, sometimes also the control of the previously identified OK and NOK parts. This function is fulfilled by DIGIPILOT 5510.

    The control device regulates dependencies of work processes by necessary acknowledgement of OK- and/or NOK parts and informs the results visually via warning lamp and acoustically via buzzer. Moreover, the mechanical arrest of a press, storing area or part feeding can be effected until an unmistakable identification for the product is done.

    The dependencies of acknowledgement, alarm and arrest are determined by the different operation modes which can be changed only by the fitter himself. The 24 V supply voltage for supplying the inputs "OK-" and "NOK acknowledg ments" is available even without a connected PLC. The DIGIPILOT 5510 is designed for rough industrial environment. As a complete unit with different switching and notification possibilities the device is priced at good value compared to a collection of separate solutions.

    DIGIPILOT 5510 is optimized to collaborate with DIGIFORCE® 9310. The two devices are connected electrically 1:1 via the PLC interface of DIGIFORCE® 9310 and a 25 pin cable model 9900-K331. If DIGIFORCE® 9310 is controlled via PLC the connection must be done on the available second bushing on DIGIPILOT 5510. DIGIPILOT 5510 offers different operation modes that need to be activated by jumpers in the 15 pin Sub-min-D connector for both modes, active as well as passive, i.e. with or without acknowledgement.

    This acknowledgement can be effected via the warning lamp on the front side of the instrument or via an external button (normally open). At the beginning of a new measurement, the present evaluation is erased. In the operation mode "Confirmation and evaluation NOK" the red light stays switched-on, even at a new measurement start. It will switchoff only after acknowledging the "NOK" result by pushing the green button.

  • Downloads

    Data sheet
    pdf 5510参数资料

Related products

Product comparison

    © 2020 波司特精密仪器(上海)有限公司 沪ICP备12015704号沪公网安备31010602000957号